Instead of being a wishy-washy dope, this time I pre-ordered.

Hopefully everything will be on schedule and in good running shape.

https://www.themodelcentre.com/372-113sf

So happy to see this and even better its a new variant of 37. I will definitely be ordering some of these, better get some overtime in

So pleased to see these released at long last.

Something doesn't look quite right with them though. It could be angle of the photos but the fuel tanks look a bit small and there's still a sizable gap between the body and bogies. Overall they don't appear to have the 37 "look".





I wonder if the new sound fitted chassis will fit the non sound bodies released a few years ago.

I don't know where the Berwick Middle School is but it's going to be somewhere in South Lanarkshire!   

how much of the tooling is new?

is it a completely new chassis?

it does still seem to be sitting a bit too high but maybe that's not the final version

Quote from: bluedepot on Today at 11:56:29 AMhow much of the tooling is new?

is it a completely new chassis?

it does still seem to be sitting a bit too high but maybe that's not the final version

Hi

The usual reason for the larger gap is so it will go around sharper curves than the prototype. It is possible to lower the body on the chassis with the older versions if you have more generous curves so it might be possible on these.

Cheers

Paul

Hopefully green ones to follow and hopefully spit head code box versions as well 

Craig

Quote from: Ensign Elliott on Today at 11:34:27 AMSo pleased to see these released at long last.

Something doesn't look quite right with them though. It could be angle of the photos but the fuel tanks look a bit small and there's still a sizable gap between the body and bogies. Overall they don't appear to have the 37 "look".

They've not corrected the ride height issue of the previous iteration of the tooling - that's why the tanks sit too high (and body/bogie gap is too large).

It can be clearly seen in Bachmann's own video - the buffers are sitting higher than the adjacent 24.5ton wagon (admittedly, assuming this is correct, but it likely is).

Disappointing, but perhaps deliberate to save money and also have them match older iterations of the 37.

I'd like to also see the running - top speed etc has been absolutely abysmal on recent designs using the gutless (in terms of RPM)small coreless motor that's in the 90, 158, 60 and new 47s - none of which I've been at all mechanically impressed with. The flywheels too, on these, are a joke.

Cheers,
Alan

Quote from: PaulCheffus on Today at 12:15:29 PMThe usual reason for the larger gap is so it will go around sharper curves than the prototype.

This is a poor excuse - lowering the body (which I've done on 20+ of these) does not hinder them going round right down to 9" curves (i.e. tighter than Bachmann's recommended minimum R2 10.5").

Cheers,
Alan

Doesn't help that it looks like it's got a drainpipe glued to the end of each nose. If they can't make that detail fine they should have omitted it - it looks ludicrous.

Otherwise apart from the height still being screwed up it doesn't look too bad.