Quote from: upnick on April 02, 2011, 11:01:47 PM

Quote from: BROADTRAIN1979 on April 02, 2011, 10:27:54 PM
i wanted mine dcc .....aaww oh well i will have to buy mine then from germany then i will have to get a boat over and back wonder how long it would take half hour i spose  

Hi  Broadtrain 

You  can get the conversion boards from Dapol  if they have them in stock   give them a ring  &  enquire 

http://www.dapol.co.uk/index.php?option=com_content&task=view&id=240&Itemid=32

Quote from: Tank on April 02, 2011, 07:30:56 PM
I finally have my cleaner.  Thanks Findus!

Any idea where I can get new pads from?  Osborns have sold out.  I'm also hoping to DCC it.

Try Dapol direct

http://www.dapol.co.uk/index.php?page=shop.product_details&flypage=shop.flypage&product_id=316&category_id=32&manufacturer_id=0&option=com_virtuemart&Itemid=59

Thank you!  Silly that they don't advertise them.

Quote from: SymonC on April 02, 2011, 11:48:10 PM

Quote from: upnick on April 02, 2011, 11:01:47 PM

Quote from: BROADTRAIN1979 on April 02, 2011, 10:27:54 PM
i wanted mine dcc .....aaww oh well i will have to buy mine then from germany then i will have to get a boat over and back wonder how long it would take half hour i spose  

Hi  Broadtrain 

You  can get the conversion boards from Dapol  if they have them in stock   give them a ring  &  enquire 

http://www.dapol.co.uk/index.php?option=com_content&task=view&id=240&Itemid=32

Symon the board shown in the link you posted is the orginial   type Dapol have used for conversion (Now, using the DCC ready board (please note we have used the existing board for this 'conversion' until more stocks are received when we will update this page).  not the one i  mentioned from Germany if you look  in  my post above it shows the original  board with the decoder hardwired

Arrived today - many thanks Upnick.  I'm just waiting for the new decoder to come now.  

Positive feedback has been left.

Many thanks for the feedback   Tank  ........  enjoy the  converted  cleaner 

Quote from: upnick on April 02, 2011, 10:15:28 PM

I am in the process of doing one and I have a brass cylinder with a protruding pin at one end left over from the innards. Anyone know where it should go.

Clean answers only please 

Cheers
Dave

It is used to regulate the flow of cleaning fluid down to the brush if you use it in cleaning mode, just pops in the reservoir.

Anyone reading this thread and wanting to purchase the Tomix cleaner, don't forget that I have one in the N'porium at £40.00 + p&p!

Peter.