DG couplings

[tank63]

I've purchased some DG couplings from Wizard models. The issue I have is sourcing electro magnets to operate them as Wizard doesn't now stock these.
Is there an alternative?
Thanks

[Will_J]

I've never used it but Peco made an electromagnet for uncoupling, code PL-25. Might be what you need.

Will.

[chrism]

I've never used it but Peco made an electromagnet for uncoupling, code PL-25. Might be what you need.

If you don't feel like spending around £8.50 for each uncoupling location, you can make them yourself for rather a lot less and not a lot of time required.

1 sewing machine bobbin, around 25p each for metal ones, Plastic ones are often cheaper but do pong a bit after use due to the heat generated in the coil.

1 M6 bolt and nut, 80p each or less. Make sure it's plated steel, not stainless since not all stainless steels are magnetic.

0.2mm enamelled copper wire, around £5/100m which will do quite a lot of uncoupler windings.

I'll leave it at that rather than cluttering up the thread at this stage. If you want to know how to make/fit them, either ask here or drop me a PM and I can supply the details.

[PLD]

I've never used it but Peco made an electromagnet for uncoupling, code PL-25. Might be what you need.

Using B&Bs which operate on the same principle as DGs, I've found the PECO electromagnets to be weak. My preference was the same PK magnets from Wizard, with SEEP (now Gaugemaster) EM-1 as the next best.

[Southerngooner]

I've got a load of electromagnets as used on James Street that I no longer need, so if you're interested we could come to a deal?

Dave

[martyn]

Dave @Southerngooner

I might need a few!

Martyn

[nabber]

I might need a few!

I've got a few as well, that I got from Dave then changed my mind - ended up using servos to move magnets under the baseboard.

Neil

[tank63]

I've got a load of electromagnets as used on James Street that I no longer need, so if you're interested we could come to a deal?

Dave

I'm interested what make and how much please

[martyn]

I agree with PLD about the magnets; Peco too weak, PK very good (but remember, they need a switch, I think, which is not included), EM1 very good and come complete with switch.

Martyn