Using Milliput

[Newportnobby]

I hate insulated rail joiners so am leaving them out on my small layout. I have 2 areas where they should be used e.g. crossovers so I've left a suitable small gap, have purchased some Milliput, and intend to fill/file those gaps.
However, reading the instructions for Milliput it seems quite hazardous stuff to skin and eyes so has anyone got decent tips for this product, please?

[crewearpley40]

Mick.

I tend to have a box of disposable plastic gloves as epoxy resin causes irritation and an old knife for modelling purposes that you never use with food . There are some harsh curing agents in the epoxy that cause irritation to skin

Hope helps you out

[Bealman]

Yes. I've used it to model dry stone walling on my layout. It sets rock hard, and I can't see it being suitable for the job you intend, where an amount of flexibility would surely be required.

Just sayiin

[Bealman]

A Hornby Minitrix signal cabin on my layout, with a carved Milliput lower half. Seriously, it's like concrete now!

[PLD]

First line of advice these days is generally "don't buy Milliput" - there are dozens of much cheaper alternative brands of epoxy putty... (Sorry...)
I've used the Hobbycraft own brand stuff which was about 1/3 the price...

It sets rock hard, and I can't see it being suitable for the job you intend, where an amount of flexibility would surely be required.

agreed...
I don't think it's the right material for the job. For the task, we used a flexible mould making resin (it was a games workshop product IIRC) - equally nasty to handle but remains flexible when cured.

[ntpntpntp]

Shouldn't be necessary to handle it.  When I've used it (and similar repair putty stuff from Lidl which is much better value)  I simply slice a tiny amount off with a scalpel and manipulate it into place using the blade. 

To be honest though, I'd persevere with the isolating joiners which will maintain proper rail alignment.  I've never had a problem with them.

[chrism]

Have to say, I've never even considered using filler to fill in a rail gap.
On the occasions where I haven't used IRJs, if I've been concerned about rails moving (through expansion, running or track cleaning) and making contact, I've just glued a sliver of plasticard in the gap.

[Bigmac]

My preferred multi purpose glue. / filler is glue'n'glaze   Will stay flexible in your application