!!

Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.


Thanks for reading,
The NGF Staff.

Author Topic: Offsetting Cobalt IP Digital via fulcrum bar  (Read 135 times)

0 Members and 1 Guest are viewing this topic.

Offline Arrowflyer

  • Trade Count: (0)
  • Full Member
  • ***
  • N Gauge Society Number: 28880
  • Posts: 102
  • Country: gb
  • Gender: Male
    • Awards
Offsetting Cobalt IP Digital via fulcrum bar
« on: September 22, 2019, 10:24:49 PM »
Looking for some advice as I canít find what I need on DCC Concepts site.

I want to shift a cobalt ip digital slightly offset from Peco code 55 point.
So normally you use the centre hole in the fulcrum bar and align this to the switch mechanism, but there are other holes in the fulcrum bar and a DCC Concepts manuals just says you can use the holes to offset the motor.
BUT, I canít get my head around this and short of setting up a test rig, thought Iíd ask.

There is advice around on how to rig up an offset using steel wire and a brass tube, but nothing as simple as just using the other holes in the fulcrum bar.  I only need to shift the motor a small amount.

Has anybody done this offsetting. If so, how does it work?

 

Please Support Us!
August Goal: £60.00
Due Date: Aug 31
Total Receipts: £25.00
Below Goal: £35.00
Site Currency: GBP
42% 
August Donations

SimplePortal 2.3.5 © 2008-2012, SimplePortal