Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.

Thanks for reading,
The NGF Staff.

Author Topic: Laser Cut Bridges  (Read 284 times)

0 Members and 1 Guest are viewing this topic.

Offline rhysapthomas

  • Trade Count: (+1)
  • Full Member
  • ***
  • Posts: 355
  • Country: gb
    • Awards
Laser Cut Bridges
« on: September 16, 2018, 05:01:51 PM »
Just painted and weathered (a bit).  A couple of Bridges from Rhinotoys on Ebay.  These are pretty good value at 1.99 for two sides.  They do a range of sizes and shapes.  Just the two sides are supplied no base or top rails but this was ideal for a current project (more on that later perhaps).  They are cut from 3mm MDF and the ones in the photo are 150mm long.  As usual no connection with them just thought them great value for money.

Offline Quinn

  • Trade Count: (0)
  • Full Member
  • ***
  • Posts: 60
  • Country: 00
    • Awards
Re: Laser Cut Bridges
« Reply #1 on: September 18, 2018, 10:56:35 AM »
They look fine and at 3mm are probably sturdy. I'm a fan of laser cut since I have built a few (Japanese) Sankei kits produced in the same way and they can achieve very fine detail, finer usually than plastic.


Please Support Us!
October Goal: £100.00
Due Date: Oct 31
Total Receipts: £69.00
Below Goal: £31.00
Site Currency: GBP
October Donations

Advertise Here