Print Page - NGS Seacow Etched Brass Fittings

Title: NGS Seacow Etched Brass Fittings
Post by: Bulliedman on September 26, 2018, 07:53:21 PM

Hi
I've just started to build an n Gauge Society Seacow Kit, that's been in the to do box for sometime. Unfortunately I've lost the instructions. The plastic bits go together really well using the thread elsewhere on here, but I can figure out all the etched bits. :help: Does anybody have a scan of a set of plans so I can work out what is what?
Thanks
Andy

Title: Re: NGS Seacow Etched Brass Fittings
Post by: PaulCheffus on September 26, 2018, 09:06:10 PM

Hi

Instructions uploaded here
(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205306-694781881.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205209-694681848.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205210-694681277.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205225-69473535.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205227-694741457.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205242-694752283.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205249-694761285.jpeg)

(http://www.ngaugeforum.co.uk/SMFN/gallery/69/982-260918205259-694771751.jpeg)

Cheers

Paul

Title: Re: NGS Seacow Etched Brass Fittings
Post by: Bulliedman on September 26, 2018, 09:08:38 PM

Hi Paul
Thanks very much, need to get on with it now :greatpicturessign: :claphappy:

Title: Re: NGS Seacow Etched Brass Fittings
Post by: PaulCheffus on September 26, 2018, 09:14:18 PM

Hi

Have fun. I've built around half a dozen now.

Cheers

Paul

Title: Re: NGS Seacow Etched Brass Fittings
Post by: koyli55002 on September 27, 2018, 05:51:51 AM

Same here - half a dozen on the "to do" list......they might have got done sooner if Farish hadn't brought theirs out !

N Gauge Forum

General Category => N Gauge Discussion => Topic started by: Bulliedman on September 26, 2018, 07:53:21 PM