Print Page - Etched steps for Bulleid Pacics

Title: Etched steps for Bulleid Pacics
Post by: 7P5F on August 31, 2015, 03:10:23 PM

Having got two of the new Farish M/N`s,superb models that they are,i have a couple of Poole built M/N`s which i`d like to detail.i`ve ordered front bogie kits from Nbrass loco but i can`t find any etched loco & tender steps.I suppose i could make them but life`s too short.

Can any one help?.
Ray.

Title: Re: Etched steps for Bulleid Pacics
Post by: robert shrives on August 31, 2015, 05:08:00 PM

Hi would etched signal ladder do the trick?
robert

Title: Re: Etched steps for Bulleid Pacics
Post by: 7P5F on August 31, 2015, 11:13:12 PM

:thankyousign:

That`s a thought,i`ll look into that.

Ray.

Title: Re: Etched steps for Bulleid Pacics
Post by: 7P5F on September 26, 2015, 02:56:05 AM

Further to my question about steps for a Poole Merchant Navy,the signal ladder did the trick although two MSE ladders had to be soldered back to back to give strength & rigidity.Anyway,these are the results of a little upgrading using an Nbrass loco Bulleid front bogie,coupling hook,coupling & vac pipes.

Macro lenses can be very cruel! :)

Ray.[smg id=29690 type=preview align=center caption="DSC 3168 copy"][smg id=29691 type=preview align=center caption="merchant navy"]

Title: Re: Etched steps for Bulleid Pacics
Post by: Newportnobby on September 26, 2015, 12:12:47 PM

Thanks for that. I have 2 sets of NBrass front bogies to fit to my old rebuilt MNs but haven't got round tuit yet :-[

N Gauge Forum

General Category => N Gauge Discussion => Topic started by: 7P5F on August 31, 2015, 03:10:23 PM