I'm looking at reducing the free small engine shed that Scalescenes are doing in Hornby magazine, and was just wondering if a straight 50% reduction from the OO scale prints will be correct for N.
any guidance appreciated
clan
yes, i think thats the case, model rail did a oo gauge signal box a few months back and im sure they said reduce by 50% for n gauge
how do we go about geting the free engine shed?
IIRC there was a discussion about this on another forum recently and the correct figure is 51%,but I doubt the extra 1% is really going to matter.
Dunno if it's what you want,but Scalescenes do an engine shed in "N" gauge,I've no idea how much colour photocopying is but at least you can print off another with Scalescenes if you make a 'male chicken' (changed by forum) up of it.
Allan
Quote from: Bikeracer on November 17, 2011, 09:13:36 PM
I've no idea how much colour photocopying is but at least you can print off another with Scalescenes if you make a 'male chicken' (changed by forum) up of it.
Allan
cheers, I'll give it a go at 51%. at work tonight :evil:
I've bought the engine shed already, but the one in Hornby is a nice little one.
cheers
alan
Quote from: michael on November 17, 2011, 09:03:16 PM
yes, i think thats the case, model rail did a oo gauge signal box a few months back and im sure they said reduce by 50% for n gauge
how do we go about geting the free engine shed?
part i was in the october edition, part two in november, and part three is due in the december one.
I might dig out the signal box edition and have a go at that as well, I'd forgotten about that one.
alan
Just remember, IAP buggered up the reproduction of Part 2, so you need to email them about a replacement ...
Quote from: MikeDunn on November 18, 2011, 09:51:46 AM
Just remember, IAP buggered up the reproduction of Part 2, so you need to email them about a replacement ...
cheers for that, I hadn't realised so I'll e-mail them.
as a matter of interest, what did they get wrong?
should be getting the dec copy over the weekend, perhaps there will be something in that.
cheers
alan
picked up the dec hornby mag today and on page 11 it gives details of who to contact to request replacement part 2.
apparently the problem was with scaling of part of the kit.