Hi all
Does anyone know of a source for Cab ends for the Class 124 (Trans-Pennine) units ?
Or is anyone experimenting with these in 3D printing ?
Trying to scratchbuild these for a Worsley Works kit and having considerable difficulty ....
Quote from: koyli55002 on August 19, 2013, 08:19:09 AM
Hi all
Does anyone know of a source for Cab ends for the Class 124 (Trans-Pennine) units ?
Or is anyone experimenting with these in 3D printing ?
Trying to scratchbuild these for a Worsley Works kit and having considerable difficulty ....
Hi
I too would be interested if you find any but I am not aware of them being available. I would also be interested in the class 123 ends as I wish to build a Hybrid unit.
Cheers
Paul
The class 123 is available from BH Enterprise, a nice kit too, mine runs on a Class 101 motor vogue, one of my better attempts at kit building!!
Quote from: bees on August 19, 2013, 10:24:27 AM
The class 123 is available from BH Enterprise, a nice kit too, mine runs on a Class 101 motor vogue, one of my better attempts at kit building!!
Hi
I am aware of them but they are to 2mm scale so slightly too small to fit the donor MK1 coaches I am using.
Cheers
Paul
you could always set to work with a set if files on the BH enterprises 128 cab casting and get the milliput out...
Quote from: dr deltic on August 20, 2013, 10:09:38 PM
you could always set to work with a set if files on the BH enterprises 128 cab casting and get the milliput out...
Hi
Been there done that, not happy with the result.
Cheers
Paul