!!

Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.


Thanks for reading,
The NGF Staff.

Author Topic: A touch of Scotch  (Read 2073 times)

0 Members and 1 Guest are viewing this topic.

Offline barneyadi

  • Trade Count: (+3)
  • Full Member
  • ***
  • N Gauge Society Number: 25703
  • Posts: 268
  • Country: england
  • Gender: Male
    • Awards
Re: A touch of Scotch
« Reply #60 on: June 26, 2018, 11:09:48 am »
Quick silly question. What size hole do I need for a peco point motor fitted from underneath. Is it 10mm?

Online Innovationgame

  • Trade Count: (+1)
  • Full Member
  • ***
  • N Gauge Society Number: 26531
  • Posts: 2081
  • Country: gb
    • The innovationgame
    • Awards
Re: A touch of Scotch
« Reply #61 on: June 26, 2018, 12:48:15 pm »
Quick silly question. What size hole do I need for a peco point motor fitted from underneath. Is it 10mm?
8mm is sufficient (that's what all mine are) but 10mm will be fine.  At  first I tried making a slot, but you have to be very accurate and I found a hole to be better.  It can be masked later, if required.
With kind regards
Laurence
My personal website is a bit of a mish mash
www.innovationgame.com

 

Please Support Us!
September Goal: £55.00
Due Date: Sep 30
Total Receipts: £55.00
Below Goal: £0.00
Site Currency: GBP
100% 
September Donations


Advertise Here