N Gauge Forum

General Category => N Gauge Discussion => Topic started by: Bornin1980something on February 16, 2017, 09:28:09 PM

Title: Nene Valley train – a simple way to add a continental loco to a British layout.
Post by: Bornin1980something on February 16, 2017, 09:28:09 PM
As most preservation observers would know, the title of this thread is a reference to the Nene Valley Railway, the only standard gauged preserved railway in Britain to operate steam locomotives from the continent. In 1985, Arnold actually advertised in Railway Modeller, on the basis that their models could be used in Britain in a Nene Valley style set up. On my layout, this is a bit of a novelty because it is normally all British. However, I wondered if a continental loco would look good with the old under scale, unloved, Lima coaches, as long as no other Mk1s were visible at the same time. Years after I first considered this, I found the continental bargain I was looking for (an old Fleischmann DR 53 0-6-0 for £46) and decided to try it out.

(http://www.ngaugeforum.co.uk/SMFN/gallery/48/5537-150217183307.jpeg)

I have now run this train several times, and it works beautifully. The only snag I found, rather belatedly, was that a third Lima coach I purchased had one coupler which was damaged and had been glued. Next time, I'd better check such old items more carefully. It is of course technically under scale, but I don't think that matters as much when the train moves and every vehicle is in scale with the vehicle it is coupled to. Despite the fact that the loco's prototype would not fit within normal British clearances, the smaller scale means that it fits within the layout's clearances easily.

Now, I know some disappointed readers would say that to recreate Nene Valley practice, I would need continental carriages. However, such carriages may be more expensive and difficult to set up in the Nene Valley's unique configuration, with one door per rake at platform level. In truth, this train is supposed to be native to my line, rather than the Nene Valley, and I think it gets the combination of continental technology and British heritage style just right.

By the way, does anyone know if an American diesel would fit through normal British layout clearances, or are they too large, even in the smaller scale?

Title: Re: Nene Valley train – a simple way to add a continental loco to a British ...
Post by: Webbo on February 16, 2017, 11:49:10 PM
With respect to your last question, I've checked out the heights above the top of the rail and widths of 4 North American diesels. These are an ES44AC (Fox Valley Models), GP9 (Atlas), FP7 (Intermountain), and an SD40 (Kato). The ES44AC is a representative of a big, fairly modern loco and has a height to the top of the horns of 32 mm and a width of 21 mm. The GP9, FP7, and SD40 have heights of 28, 29, and 30 mm respectively and widths of 21, 22, and 21 mm respectively.

Hope this helps.
Webbo
Title: Re: Nene Valley train – a simple way to add a continental loco to a British ...
Post by: Webbo on February 17, 2017, 07:37:21 AM
I should add that I run a few trains from the UK on my Canadian layout with impunity without worrying about whether my line is a preservation railway or not. The trains themselves are the stars of the show and I just like to see them run no matter where they are from. I've not yet got so far as Japanese or continental rolling stock, but my limited restraint is still in danger of failing.   

Webbo