!!

Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.


Thanks for reading,
The NGF Staff.

Author Topic: Point motor wiring  (Read 827 times)

0 Members and 1 Guest are viewing this topic.

Offline geoffc

  • Trade Count: (0)
  • Full Member
  • ***
  • N Gauge Society Number: 24557
  • Posts: 229
  • Country: gb
  • Gender: Male
    • Awards
Re: Point motor wiring
« Reply #15 on: September 21, 2017, 10:36:55 am »
I have found using the built in Seep switch or with Peco the add on switch very fiddley to set up correctly.  In the end I used DCC Concepts Masterswitch V2, these have a built in cd unit and solder pads for frog switching. Unfortunately these seem to be no longer available from the manufacturer but you may be able to find them in some dealers or at a Toy Fair, I managed to get four brand new ones recently in unopened packages for 20.

Geoff

 

Please Support Us!
December Goal: £55.00
Due Date: Dec 31
Total Receipts: £55.00
Below Goal: £0.00
Site Currency: GBP
100% 
December Donations


Advertise Here
anything