!!

Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.


Thanks for reading,
The NGF Staff.

Author Topic: Beyer Garret kit build, advice and photos needed  (Read 493 times)

0 Members and 1 Guest are viewing this topic.

Offline Dr Al

  • Trade Count: (+49)
  • Full Member
  • ***
  • Posts: 4095
  • Country: gb
  • Gender: Male
    • Awards
Re: Beyer Garret kit build, advice and photos needed
« Reply #15 on: February 02, 2018, 03:20:30 pm »
OUCH Alan, I have a new skill then to master, whilst I can Mig weld, stick weld, braze, electrical solder, this will be a new skill to investigate and learn. Who sells the low melt solder? Do I use Bakers flux?
Kind regards from Fred

You need correct flux suitable for whitemetal.

I use Carr's Red label flux, available from Phoenix precision and also 70degree solder from them. You also will need a temperature controlled iron, set below the melting point of whitemetal, otherwise you'll likely end up with more holes or a big blob!

Cheers,
Alan
Quote from: Roy L S
If Dr Al is online he may be able to provide a more comprehensive answer.

 

Please Support Us!
May Goal: £55.00
Due Date: May 31
Total Receipts: £65.00
Above Goal: £10.00
Site Currency: GBP
118% 
May Donations


Advertise Here
anything