!!

Not Registered?

Welcome!  Please register to view all of the new posts and forum boards - some of which are hidden to guests.  After registering and gaining 10 posts you will be able to sell and buy items on our N'porium.

If you have any problems registering, then please check your spam filter before emailing us.  Hotmail users seem to find their emails in the Junk folder.


Thanks for reading,
The NGF Staff.

Author Topic: Salmon and Sturgeons with cranes (using 3D prints)  (Read 1580 times)

0 Members and 1 Guest are viewing this topic.

Offline Snowwolflair

  • Trade Count: (+1)
  • Full Member
  • ***
  • N Gauge Society Number: 25174
  • 2mm Association Number: 4194
  • Posts: 2300
  • Country: gb
  • Gender: Male
    • Awards
Re: Salmon and Sturgeons with cranes (using 3D prints)
« Reply #30 on: May 24, 2018, 10:10:46 am »
BRM (June)has a 7 page spread on modelling a Salmon in OO, and picture feature on the Real Thing.

The construction article would be helpful for the super detail squad and the NGS kit

Yes its a good article despite being in OO  :)

Shows a lot of detail and a photo of the other crane variant which may become available again from the NGS shop at some point.

 

Please Support Us!
September Goal: £55.00
Due Date: Sep 30
Total Receipts: £55.00
Below Goal: £0.00
Site Currency: GBP
100% 
September Donations


Advertise Here
anything